High-current terminal plug type series terminal: it is made up of two parts of plug and pull connection, one part of the wire is pressed tight, and then plug into the other part, this part is welded to the PCB board. This connection bottom mechanical principle, this anti-vibration design has guaranteed the product long-term airtight connection and the finished product service reliability. Mounting ears can be added at both ends of the socket, which to a large extent can protect the connector and prevent the poor arrangement of the connector. At the same time, this socket design can ensure that the socket can be inserted into the parent correctly. Sockets may also have mounting and locking clips. The mounting buckle can be more firmly fixed to the PCB board, and the locking buckle can lock the parent and socket after installation. A wide variety of socket designs can be combined with different maternal insertion methods, such as: horizontal, vertical or tilted to the printed circuit board, etc., can be selected according to customer requirements in different ways. You can choose metric wire gauge or you can choose standard wire gauge.

Large current terminal consists of insulating base, insulation plate, wire, insulation base composition, connection and a seat on the insulating base on insulating clapboard, connection parts including wire clamp, screw, nut and bearing box, bearing box is u-shaped, wire clip in the bearing box, on the surface of the nut and screw along the support frame on both ends of the u-shaped long hole pin wire clip, wire clip is made up of wire clamp and conducting strip, wire clip on surface on both sides of the bumps much bump, bump on one to two convex rib, is characterized by conductive sheet surface protrusions on both sides more convex block, large current terminal lug and central on the surface of circular arc, One to two convex rib, circular arc surface form serrated convex block and the convex block, conductive sheet surface in the middle of a raised platform, platform central threaded holes are connected to the insulating base by the bolt, conductive sheet at each end surface processes under a positioning round block connected with u-shaped support frame, the large current terminals on two pieces of wire clip into conductive piece on both sides of the platform, and respectively with conductive piece of sandwich, large current terminals on the wire clamp with conductive convex blocks (staggered bite the wire clamp.

The high-current terminal and the voltage terminal are; Terminal terminal voltage and current is no different from appearance, just when wiring should pay attention to the wiring diagram to see the watch (general table cover would have) protection plate of the two terminals of the main difference is the terminal voltage is also called the common terminal cannot disconnect, large current terminals only through can be disconnected connection terminal, large current terminal can usually be disconnected to test itself.